Trade Select Wall Wrap MD: What Perth Buyers Should Check

Trade Select Wall Wrap MD is a medium-duty breathable wall wrap used when a standard light-duty wrap is not robust enough for the wall system or site conditions. The first thing to check is whether the project really needs a vapour-permeable wall wrap, because breathable wraps, reflective foil wraps, and cavity batts all do different jobs in the wall build-up.

The best place to start is the Trade Select Wall Wrap MD product page, then the LD vs MD wall wrap guide if you need to compare duty level before ordering.

What It Is

Trade Select Wall Wrap MD is a Class 4 vapour-permeable breathable membrane designed for wall systems behind external cladding. On a practical job, that means it helps the wall shed water and resist air ingress while still allowing moisture vapour to move out of the assembly.

The key difference from the LD version is strength. MD is the tougher option, so it is usually the better fit where the build is more exposed, the wall area is larger, or the installation conditions are less forgiving. It is still a breathable wrap, not a foil insulation layer and not the bulk batt inside the cavity.

When It Makes Sense

This product usually makes sense when:

  • the wall build-up calls for a vapour-permeable wrap behind cladding
  • the project needs a tougher wrap than the LD version
  • the build is more exposed, larger, or likely to benefit from a stronger membrane during installation
  • the framing is timber or steel and the specification is built around a breathable wall-wrap layer

In Perth, this often suits two-storey homes, more exposed wall areas, and jobs where you want the added confidence of a medium-duty membrane without moving into a different wrap category altogether.

When It Does Not Make Sense

It is usually the wrong fit when the wall only needs a straightforward light-duty breathable wrap and there is no reason to pay for a tougher membrane. It is also the wrong product if the wall design actually calls for reflective foil performance, a thermal break, or a cavity batt rather than a breathable wrap.

If the specification is still unsettled, the first decision should be wrap type, not duty level. Choosing MD by name alone is not enough if the wall detail itself has not been confirmed.

What To Check Before Buying

  • Confirm the wall assembly calls for a vapour-permeable wall wrap.
  • Check whether the project conditions justify MD instead of LD.
  • Review the cladding and framing detail so the wrap category matches the wall system.
  • Check roll coverage and installation constraints before ordering.
  • Keep the comparison focused on breathable wraps, not unrelated foil or batt products.

How It Compares With Similar Products

The closest in-range comparison is the Trade Select Wall Wrap LD product page. Both are breathable wall wraps, but MD is the better fit when the project needs more durability than the LD version.

If you still need to separate breathable wraps from other envelope products, read the what is wall wrap guide, the building wrap guide, and the Trade Select product guide. Those comparisons help when the bigger question is whether a breathable wrap is the right layer in the first place.

Before You Order

If you are looking at Trade Select Wall Wrap MD, the main decision is whether the wall needs a breathable membrane and whether the tougher medium-duty version is justified over LD. This product makes the most sense when the wall system needs vapour permeability, the site or build detail is a little more demanding, and the lighter-duty wrap is no longer the best fit.

Start with the Trade Select Wall Wrap MD product page, compare it with the LD version, and use the LD vs MD guide if you need to confirm whether medium duty is worth it for the project.

Back to blog